Duck and Cover

I thought of this idea after seeing a topic on the TW boards (thewastes).
thought I might take a stab at my own idea of it, and what do you know-- I actually finished!

First time I have made a weapon in Ms3d, and first time I have completed something I began in Ms3d.


Page or Bigger pic

nice, now all you have to do is texture that baby and your set

I like it

My first complete model calls for My first complete texture. heheh.

Where's my animated rubix cube your lazy bugger!?

Oh and good work, cheers m8.

bah, my computer can't handle the damn rubix cube... too many boxes, and too much to render... made me sad.

what's the back filled with? cheese?

empty it out, unless it's going to be some hollow thing u can beat people over the head with

make it like a standard assualt rifle butt and it would look coolerish,

but then again, i'm a newb3?

Looks like a crossbreed between a FAMAS and that gun from CS... 3-3, the one with 50 shots and the clip on top.... Nice.

the butt looks really awkward, like iokhus said...
As if it has absolutely no point, but to be in the way

It's called a P-90.
I think it is worthy of a CS skin, you should figure out how to make it a skin when you finish it.

Smiley: FN P90c. How can you not know that? It was in Fallout and is one of the best SMGs ever.

I remember the design and it's usefulness, but unless it has a *cool* name it's not worth remembering.

It looked like crap in Fo though... all white/silvery, like it had no skin.

the huge buttstock is where the bullets are oriented... i guess that how i set this up it has to use caseless ammo, because there is nowhere for the shells to be ejected without getting in the way, unless it was on the far back right side, but then it would be for right handed people only.

I'm skinning/tweaking now... expect something new in some time.

atoga wrote:Smiley: FN P90c. How can you not know that? It was in Fallout and is one of the best SMGs ever.

it's not very retro-canon though, being developed in the late 80s and all that?

hmmm... what do I need to change to make it more, er... Ergonomic?
plus I don't know what to do with the shells, and the handle.

http://www.deviantart.com/view/3041006/

added:
i made the buttstock shorter... and fixed the handle a little. I need idea's for a cool looking scope/aiming system, something that you could use that was mounted close to your face.

Plus, the p90 along with the g36 are almost always in movies set in the future. they look so furturistic don't they! (and cool)

Gimp Mask wrote:it's not very retro-canon though, being developed in the late 80s and all that?

Yea it doesn't belong in Fallout, but still it is very cool.

Nice.....

i say remove that handle and put on a scope for maximum penetration and um didn't u say the caseless ammo goes in the butt or something?

texture it with tinfoil and u have pemp.

the caseless firing mechanism recoils...

the P90's bullets lay sideways and are rotated by this special thing on the clip itself... I don't know how to make it either one of these mechanisms.

ok, wtf? i still think handle bar = no good, scope = good

i mean put a shoulder strap thing instead of handle bar, uknow?

It has a groove down the middle... my first gun model, so I'm not up on my aiming fixtures. Post a pic of a scope you think looks fitting.